Technology

Process cooling for plastics factories: chillers, moulds and energy

3 Nov 2026
Technical
Process cooling for plastics factories: chillers, moulds and energy

2 min read

In a plastics factory, cooling is part of the process. Molten plastic has to be cooled before a part can be released, so the cooling system sets how fast machines can cycle and how consistent the parts are. It is also one of the plant's largest electricity loads.

Where cooling is used

  • Moulds: chilled water flows through channels in the mould to solidify the part. In injection moulding, cooling is usually the largest share of the cycle time.
  • Hydraulic oil: hydraulic machines need their oil kept in a safe temperature range.
  • Feed throats, barrels and hot-runner systems: some zones must be kept from overheating.
  • Extrusion and blow moulding: cooling baths, calibrators, chill rolls and blown-film air rings.
  • Compressed air: air compressors and dryers reject heat that has to be removed.
  • The building itself: comfort and humidity control in production and warehouse areas.

Why temperature stability matters

Uneven or unstable mould cooling causes defects such as warping, sink marks and dimensional variation, and forces longer cycles to compensate. A cooling system that holds a steady supply temperature at the flow each machine needs protects both output and quality.

Not every load needs the coldest water

A common source of waste is running every load from one low-temperature chilled-water loop. Many loads, such as hydraulic oil coolers and some machine circuits, can be served by warmer water from a cooling tower or a separate, higher-temperature loop. Chillers work far more efficiently at higher supply temperatures, so matching each load to the warmest water it can accept saves energy.

Where plastics plants lose cooling energy

  • One cold loop for everything, as above.
  • Chillers and pumps running at full output when only part of the machines are running.
  • Scale and fouling in mould channels and heat exchangers, which cut heat transfer and force colder water and more flow.
  • Constant-speed pumps with throttled valves.
  • Ageing chillers with falling efficiency (rising kW/TR).
  • No metering, so nobody can see the plant's real efficiency.

Practical steps

  • Measure whole-plant kW/TR and the load profile across shifts.
  • Group loads by the temperature they really need.
  • Add variable-speed drives to pumps and tower fans.
  • Treat water and clean mould channels and heat exchangers on a schedule.
  • Sequence chillers to production, not to the clock.
  • Replace end-of-life chillers with efficient, correctly sized ones.

Without capital spending

With Cooling-as-a-Service, Infinity CoolMaster designs, funds, installs and operates the chiller plant for the factory, and the factory pays for efficient cooling out of the savings, with a minimum saving guaranteed in writing and measured monthly. Our first project, for Platinum Pro Plastic, is in testing and commissioning in November 2026.

ShareLINELinkedInFacebook