Technology

Data center cooling and PUE: how cooling efficiency drives the number

3 Nov 2026
Technical
Data center cooling and PUE: how cooling efficiency drives the number

2 min read

Power Usage Effectiveness (PUE) is the most widely used efficiency metric for data centers. It compares the energy the whole facility uses with the energy that reaches the IT equipment. Because cooling is the largest load after the IT itself, cooling efficiency decides most of the number.

What PUE measures

PUE = total facility energy ÷ IT equipment energy

A PUE of 1.0 would mean every kilowatt-hour goes to IT. Anything above 1.0 is overhead: cooling, power distribution losses, lighting and other building loads. Measure it over a full year, because a single moment can look much better or worse than reality.

Why cooling dominates

IT equipment turns almost all of its power into heat, and all that heat must be removed, 24 hours a day, in Thailand's hot and humid climate. Chillers, pumps, cooling towers, computer-room air handlers and fans together form the biggest share of the overhead.

Ways to improve cooling efficiency

  • Contain hot and cold aisles, so cold air reaches IT inlets without mixing with hot exhaust.
  • Raise supply air and chilled-water temperatures within the ranges your IT equipment is specified for.
  • Use variable-speed fans and pumps that follow the real heat load.
  • Optimise chillers, pumps and towers together rather than one by one.
  • Use economiser modes where climate and design allow.
  • Track whole-plant kW/TR alongside PUE, so cooling plant performance is visible.

Protecting uptime

Efficiency cannot come at the expense of availability. Two principles keep the risk low:

  • Keep redundancy: changes must respect the facility's design (for example N+1 or 2N) and its maintainability requirements.
  • Start in shadow mode: optimisation software recommends setpoints, and operators review and approve them for a period before any automation is switched on.

Measuring the result

Cooling savings should be measured, not estimated. Metering the cooling plant and comparing it with an agreed baseline, in line with the IPMVP protocol, shows exactly how much of a PUE improvement comes from cooling.

Cooling-as-a-Service for data centers

Infinity CoolMaster designs, finances, installs and operates efficient, redundant cooling plants with no upfront cost. Optimisation starts in shadow mode, energy data is verified every month and supports your PUE reporting, and a minimum 10% saving is guaranteed in writing.

ShareLINELinkedInFacebook